Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?

Posted by: Pdfprep Category: 200-101 Tags: , ,

Refer to the exhibit.

Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?
A .  This switch has more than one interface connected to the root network segment in VLAN 2.
B .  This switch is running RSTP while the elected designated switch is running 802.1d Spanning Tree.
C .  This switch interface has a higher path cost to the root bridge than another in the topology.
D .  This switch has a lower bridge ID for VLAN 2 than the elected designated switch.

Answer: C

Explanation: These four parameters are examined in order to make root bridge , root port , designated port. Other switch has lowest Sending Bridge ID or Sending Port ID so vlan 2 is not the root port.

Leave a Reply

Your email address will not be published.