PdfPrep.com

How is the peer address configured on the Expressway-C when Expressway-E has only one NIC enabled and is using static NAT mode?

An engineer wants to configure a zone on the Expressway-E to receive communications from the Expressway-C in order to allow inbound and outbound calls.

How is the peer address configured on the Expressway-C when Expressway-E has only one NIC enabled and is using static NAT mode?
A . Expressway-E FQDN
B . Cisco UCM FQDN
C . Expressway-E DHCP
D . Cisco UCM DHCP

Answer: A

Exit mobile version