Passing 300-410 exam is a first step for you to get the CCNP Enterprise certification. With studying all of Implementing Cisco Enterprise Advanced Routing and Services (ENARSI) 300-410 exam prep questions dumps, you can test your skills to check if you have a good understanding of the exam topics or not. All the Cisco 300-410 exam prep questions are collected from the real test by our certified experts, who update the 300-410 questions frequently according to the changes at the testing center.
A network engineer is investigating a flapping (up/down) interface issue on a core switch that is synchronized to an NTP server. Log output does not show the time of the flap. Which command allows...
Which security feature can protect DMVPN tunnels?A . IPsecB . TACACS+C . RTBHD . RADIUSView AnswerAnswer: A
Refer to the exhibit. R1 is being monitored using SNMP and monitoring devices are get ng only partial information. What action should be taken to resolve this issue?A . Modify the CoPP policy to...
Which list defines the contents of an MPLS label?A . 20-bit label; 3-bit traffic class; 1-bit bottom stack; 8-bit TTC . 32-bit label; 3-bit flow label; 1-bit bottom stack; 8-bit hop limit.D . 20-bit...
Refer to the exhibit. A network engineer for AS64512 must remove the inbound and outbound traffic from link A during maintenance without closing the BGP session so that there is still a backup link...
Refer to the exhibit. After applying IPsec, the engineer observed that the DMVPN tunnel went down, and both spoke-to-spoke and hub were not establishing. Which two actions resolve the issue? (Choose two.)A . Configure...
Refer to the exhibit. An administrator that is connected to the console does not see debug messages when remote users log in. Which action ensures that debug messages are displayed for remote logins?A ....
What does IPv6 Source Guard utilize to determine if IPV6 source addresses should be forwarded?A . ACEB . ACLsC . Binding TableD . DHCPView AnswerAnswer: C
An engineer is configuring a network and needs packets to be forwarded to an interface for any destination address that is not in the routing table. What should be configured to accomplish this task?A...
Which configuration enables the VRF that is labeled `'inet'' on FastEthernet0/0?A . R1(config)# ip vrf Inet R1(config-vrf)#ip vrf FastEthernet0/0B . R1 (conflg)#ip vrf Inet FastEthernet0/0C . R1(config)# ip vrf Inet R1(config-vrf)#interface FastEthernet0/0 R1(config-if)#ip vrf...
