Where should the technician configure these settings?

December 25, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician needs to initially configure a server from a bare metal condition in the following area. - Processor settings - Disk configuration - iDRAC network settings. The technician can only reboot the server once...

Read more +

What should the technician do to resolve this issue?

December 22, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician is remotely installing ESXi 6.0 on a PowerEdge R640 in BIOS boot mode. The system has dual internal SD cards. After the OS is installed, the system reboots and shows an error screen...

Read more +

How should the technician install the OS?

December 21, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician has the ISO image of an OS that they need to install on a server in a remote location. They are already logged into the iDRAC. How should the technician install the OS?A...

Read more +

What is the result?

December 21, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician creates two virtual disks and assigns a dedicated hot spare to each virtual disk. They also create a global hot spare. A drive fails on the second virtual disk. What is the result?A...

Read more +

What is the minimum iDRAC license required to perform this task?

December 18, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician needs to install the OS on a server remotely using iDRAC. What is the minimum iDRAC license required to perform this task?A . ExpressB . EnterpriseC . BasicD . Baseboard Management ControllerView AnswerAnswer:...

Read more +

Where can the technician configure the LCD?

December 16, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

Before deploying a server, a customer needs a technician to configure the front panel LCD to display a custom message that contains the customer’s help desk phone number. However, the server cannot be rebooted. Where...

Read more +

What actions does the technician need to take to achieve this?

December 16, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician needs to set a server to always attempt PXE boot before booting to the hard drive. What actions does the technician need to take to achieve this?A . Change the Boot Sequence so...

Read more +

Which memory mode should be configured so that all memory is seen by the OS?

December 16, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A server is equipped with 2 CPUs and 12x 8 GB DIMMs, for a total of 96 GB. The OS is not seeing all the memory. Which memory mode should be configured so that all...

Read more +

What troubleshooting steps should the technician take to resolve this issue?

December 11, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician plugs in a server that has dual power supply units. After powering on the system, they notice that the power supply status indicators blink green then turn off. What troubleshooting steps should the...

Read more +

How can the technician find out what the error message was?

December 7, 2020PdfprepDES-4121DECS-IE, DES-4121 exam questions, DES-4121 practice exam

A technician is sent on-site to troubleshoot a server that produced an error message during the most recent POST but then completed the POST and booted to the operating system. The user cannot remember the...

Read more +