What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2?

Posted by: Pdfprep Category: 200-101 Tags: , ,

Refer to the exhibit.

What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)
A .  Router(config)# interface fastethernet 0/0 Router(config-if)# ip address 192.168.1.1 255.255.255.0 Router(config-if)# no shut down
B .  Router(config)# interface fastethernet 0/0 Router(config-if)# no shut down Router(config)# interface fastethernet 0/0.1 Router(config-subif)# encapsulation dot1q 10 Router(config-subif)# ip address 192.168.10.1 255.255.255.0 Router(config)# interface fastethernet 0/0.2 Router(config-subif)# encapsulation dot1q 20 Router(config-subif)# ip address 192.168.20.1 255.255.255.0
C .  Router(config)# router eigrp 100 Router(config-router)# network 192.168.10.0 Router(config-router)# network 192.168.20.0
D .  Switch1(config)# vlan database Switch1(config-vlan)# vtp domain XYZ Switch1(config-vlan)# vtp server
E .  Switch1(config)# interface fastethernet 0/1 Switch1(config-if)# switchport mode trunk
F .  Switch1(config)# interface vlan 1 Switch1(config-if)# ip default-gateway 192.168.1.1

Answer: B,E

Explanation:http://www.cisco.com/en/US/tech/tk389/tk815/technologies_configuration_example09186a00800949fd.shtml https://learningnetwork.cisco.com/servlet/JiveServlet/download/56692461/Router%20on%20a%20Stick.pdf.

Leave a Reply

Your email address will not be published.