What is the solution of the fault condition?

What is the solution of the fault condition?
A . In Configuration mode, using the interface range Fa 1/0/1 -2, then no switchport-security interface configuration commands. Then in exec mode clear errdisable interface fa 1/0/1-2vlan 10 command
B . In Configuration mode, using the interface range Fa 1/0/1 -2, then no switchport-security, followed by shutdown, no shutdown interface configuration commands.
C . In Configuration mode, using the interface range Fa 1/0/1 -2, then no switchport-security interface configuration commands.
D . In Configuration mode, using the interface range Fa 1/0/1 -2, then no switchport-security interface configuration commands. Then in exec mode clear errdisable interface fa 1/0/1, then clear errdisable interface fa 1/0/2 commands

View Answer

Answer: B

Explanation:

To allow Client1 to access the network, we must remove the port security configuration command that is allowing only the device with a MAC address of 0000.0000.0001. Since this port will still be in an errdisable state after this, we must also issue a shutdown/no shutdown to enable the port.