Passing 200-101 exam is a first step for you to get the CCNA certification. With studying all of Interconnecting Cisco Networking Devices Part 2 (ICND2) 200-101 exam prep questions dumps, you can test your skills to check if you have a good understanding of the exam topics or not. All the Cisco 200-101 exam prep questions are collected from the real test by our certified experts, who update the 200-101 questions frequently according to the changes at the testing center.
Which protocol provides a method of sharing VLAN configuration information between two Cisco switches?A . STPB . VTPC . 802.1QD . RSTPView AnswerAnswer: B Explanation:Understanding VLAN Trunk Protocol (VTP) http://www.cisco.com/en/US/tech/tk389/tk689/technologies_tech_note09186a0080094c52.shtml Introduction VLAN Trunk Protocol...
Which port state is introduced by Rapid-PVST?A . learningB . listeningC . discardingD . forwardingView AnswerAnswer: C Explanation:Spanning Tree from PVST+ to Rapid-PVST Migration Configuration Example Reference 1: http://www.cisco.com/en/US/products/hw/switches/ps708/products_configuration_example09186a 00807b0670.shtml Reference 2: http://www.cisco.com/en/US/tech/tk389/tk621/technologies_white_paper09186a0080094cfa.shtml PVST+...
Which commands are required to properly configure a router to run OSPF and to add network 192.168.16.0/24 to OSPF area 0? (Choose two.)A . Router(config)# router ospf 0B . Router(config)# router ospf 1C ....
Refer to the exhibit. Each of these four switches has been configured with a hostname, as well as being configured to run RSTP. No other configuration changes have been made. Which three of these...
Refer to the exhibit. Given the output shown from this Cisco Catalyst 2950, what is the reason that interface FastEthernet 0/10 is not the root port for VLAN 2?A . This switch has more...
What are two drawbacks of implementing a link-state routing protocol? (Choose two.)A . the sequencing and acknowledgment of link-state packetsB . the requirement for a hierarchical IP addressing scheme for optimal functionalityC . the...
A router is running three routing processes: RIP, OSPF, and EIGRP, each configured with default characteristics. Each process learns a route to the same remote network. If there are no static routes to the...
Which three of these statements regarding 802.1Q trunking are correct? (Choose three.)A . 802.1Q native VLAN frames are untagged by default.B . 802.1Q trunking ports can also be secure ports.C . 802.1Q trunks can...
Refer to the exhibit. What commands must be configured on the 2950 switch and the router to allow communication between host 1 and host 2? (Choose two.)A . Router(config)# interface fastethernet 0/0 Router(config-if)# ip...
What does a router do if it has no EIGRP feasible successor route to a destination network and the successor route to that destination network is in active status?A . It routes all traffic...
